1 reply to this topic

[Ethan1395]

Ok, let's start with the fact that I know nothing about ComputerCraft, so I will need step by step instructions on how to this.

I need to make an elevator floor indicator using monitors, I have my elevator built with the Dynamic Transport mod (found here: http://www.minecraft...rs-in-minecraft), I have it set up so a different redstone signal is emitted when stops on a particular floor, I also have a monitor set up on each floor connected to a single computer with a network cable.

Can someone please tell me how I can make it so the monitors display the elevators current position with step by step instructions.


Thank you in advanced, God Bless you all.

[Bomb Bloke]

Ethan1395, on 08 May 2015 - 08:49 AM, said:

I know nothing about ComputerCraft

What about programming in general?

Ethan1395, on 08 May 2015 - 08:49 AM, said:

I have it set up so a different redstone signal is emitted when stops on a particular floor

How are these signals set up, and where are they going?

What're the redstone signals running through, and what version of ComputerCraft are you using?