2 replies to this topic

[Britizz]

hello,
i will soon go in the moon (with galacticraft of course) and i make a program for safety produce (without interuption).
there is the specifications :

when all reactors (two reactors) are down, one reactor are activated
when one reactor are down the other are activated.

but i can do that beacause my skils on conditional statments are limited
can you give me an advice or a program (thank's you very much if someone do that) for competing my program and terminate him (i will not leave on the moon until the program is ready).

thank's you

[TheOddByte]

I'm not 100% sure what you want, but is it this logic you mean?

Psuedo-code

--# This will store what reactor we're actively using
local index  = nil;

--# Wrap and store the reactors in a table since we'll use the variable above
--# to keep track of which one we're using
local reactors = {
	peripheral.wrap( "<name or side of reactor>" );
	peripheral.wrap( "<name or side of reactor>" );
}




--# Infinite loop
while true do

	--# If the index variable is nil we'll check if there is any reactor active
	--# and choose which one we'll keep track of
	if not index then

		--# We loop through all reactors and check if
		--# we find one that's already active
		for i, reactor in ipairs( reactors ) do
			if reactor.active() then
				index = i
				break
			end

			--# If we didn't find any active reactor then
			--# We'll choose the first one in the table to use
			if not index then
				index = 1
				reactors[index].activate() --# Here we activate it
			end
		end

	else

		--# If the reactor isn't active we'll activate another one
		--# so we'll increment the index variable with one to continue
		--# to the next reactor
		if not reactors[index].active() then
			index = index + 1 <= #reactors and index + 1 or 1
			reactors[index].activate()
		end
	end
    sleep( 0.5 )
end

Do take note that this is for the most part only a psuedo-code and I haven't checked what methods actually are available for the reactors in galacticacraft nor tested the code.
But from what I understood you only want one reactor active at a time?

Edited by TheOddByte, 20 April 2018 - 02:50 PM.

[Britizz]

yes that's it

EDIT : THANK'S YOU SO MUCH it's works (with correct function)

Edited by Britizz, 20 April 2018 - 05:23 PM.